Two phased interior construction of 5-story cGMP manufacturing facility consisting of approximately 20,000 sq ft of cleanroom space.
1st Phase included fitout of the first floor, third floor and fourth floors including labs, offices, conference rooms, training spaces and support spaces including MEP rooms on the first floor.
2nd Phase included fitout of the fifth floor and penthouse equipment including manufacturing and production GMP clean rooms and support spaces, as well as QC labs and additional office spaces.
GMP warehouse space on the first floor is also included in this phase.
Scope of work included all Mechanical and Plumbing systems, including process gas distribution piping serving the GMP production areas and QC labs. Plumbing systems included below grade waste, vent, and storm piping, above grade waste, vent, storm, lab waste and vent, natural gas, and all domestic water systems (cold, hot, recirc, tepid water, lab cold, lab hot).
Process systems included Biowaste vent, RO/DI, CO2, CA, N2, VAC, & O2. Mechanical systems included all ductwork (Exhaust, Supply, Return, OA), Chilled Water, Glycol Cooling Water, Heating Hot Water, Condenser Water, Plant Steam and Condensate, Makeup Water, Condensate Drain, and Refrigeration Piping.
Primary equipment included (8) Custom AHU’s, (1) DOAS Unit, (3) Air-Cooled Chillers, (120) Water-Source Heat Pumps, (3) Hot Water Boilers, (2) Steam Boilers, (18) Exhaust Fans, (10) Pumps, (1) Duct Mounted Humidifier, (22) Loose VFD’s, (1) Storage Tank, (30) Duct Mounted Reheat Coils, (2) Air Curtains, (1) RO/DI Skid, (1) Waste Nuetralization Skid, (1) Lab Air Compressor Skid, and (1) Lab Vacuum Pump Skid.
Primary plumbing equipment included all floor drains, trench drains, lab sinks, floor sinks, mop basins, recessed emergency eyewash stations, backflow preventor stations, hot water heaters including instantaneous, master thermostatic mixing valve assembly, and recirculation pumps.